- FOCUSRITE SCARLETT 2I2 DRIVER WINDOWS 10 64 BIT MANUAL
- FOCUSRITE SCARLETT 2I2 DRIVER WINDOWS 10 64 BIT SOFTWARE
- FOCUSRITE SCARLETT 2I2 DRIVER WINDOWS 10 64 BIT WINDOWS 7
I was forced to toggle to "Line" mode and bypass the preamps, which seemed to be of very bad quality. I used it around 6 months before changing itįrom the start it was impossible to record without the clipping LED turning on, even with the gain at 0.
FOCUSRITE SCARLETT 2I2 DRIVER WINDOWS 10 64 BIT MANUAL
With Live, the latency is around 14ms at 256 samples, which is slightly perceptibleįurther down I explain the problems I've had with this card.Įasy setup, no incompatibilities found, the manual is very basic. I use it on a Mac (OSX 10.9) and have no stability issues The plastic buttons do not seem very sturdy (especially the inst/line switches)Ģ line/instrument inputs on the front panel Red aluminum housing, which looks very nice and solid Although the lack of a MIDI in/out is a bit of a bummer, if you just need to record one or two instruments or if you need an interface for your mobile production setup, this is definitely something to consider. It’s a great interface for someone who doesn’t need a lot of inputs, outputs, or advanced DSP features. It would certainly drive lower impedance headphones satisfactorily. There’s not a ton of gain and I need to set it about half way on the headphone volume knob to get to my preferred listening level, but it does drive them okay and the DAC is very good. The headphone output is not bad even with high impedance headphones like my 250 ohm Beyerdynamic DT880s. It’s a fairly low-noise unit, I’ve mostly used it for recording guitars or synths directly and I have no real complaints there. All other functions like changing the sample rate and bit depth are done through the Windows Control Panel.
FOCUSRITE SCARLETT 2I2 DRIVER WINDOWS 10 64 BIT SOFTWARE
The software for controlling the interface is a one function affair-changing the buffer length. Very clearly labeled knobs and switches for all of the functions. It’s a pretty simple interface and very straight forward to use. Outside of that, absolutely no driver problems or latency when recording instruments. It's possible to get the latency under 10ms round trip, however, I ran into driver instability when trying to go lower than that where the driver would sporadically crash and cause lots of distortion and slowed down audio.
FOCUSRITE SCARLETT 2I2 DRIVER WINDOWS 10 64 BIT WINDOWS 7
I've been using the 2i2 for 2 years with Renoise, Maschine, and REAPER on both a Windows 7 and 8 64-bit system using an Intel i5 2500k 4.5ghz. The one downside to the unit is that it doesn’t have a MIDI input/output which some audio interfaces in this price range do have. The interface is bus-powered and connects to your computer from one USB port on the back. There’s also a headphone output with an independent volume knob. You can enable direct monitoring via a switch on the front and control the overall output of the audio interface via the monitor knob. There are 2 ¼” TS outputs on the back for your monitors. There’s a 48v button for microphones that require phantom power. These inputs can be switched between line and instrument levels independently of each other. The 2i2 features 2 XLR-TRS combo inputs with independent volume knobs that have an LED ring around them to indicate levels.